Posted on

ez-SAB-gloves install guide

V2.0 glove install (clear)

V1.0 glove install (red)

Bring your ez-SAB-glove opening through the ring.
Bring your ez-SAB-glove™ opening through the ring.
Stretch the glove cuff evenly around the wring. This may take a few tries as you're stretching the glove material to fit the ring.
Stretch the glove cuff evenly around the wring. This may take a few tries as you’re stretching the glove material to fit the ring.
Insert your ez-SAB-port™ through the wall of your still air box.
Insert your ez-SAB-port™ through the wall of your still air box.
Orient the glove so the thumb of the glove is in a natural position. While holding the inside ring steady, begin screwing the outside port hole into your glove ring.
As you’re tightening the port into the glove ring,  the glove material is being drawn into the threads. Once the material has drawn into the threads, Stop. Now hold the outside port steady and finish tightening the port together by rotating the inside glove ring until snug.
Repeat the installation steps for both gloves sets, paying special attention to the orientation of the the thumbs on your gloves.  They should be in a natural up position. You’ve now completed the ez-SAB-glove install.
Powder your gloves
In your port kit you’ve been provided with a small amount of power. It’s best to powder your gloves before the first use.  This makes it easy to take the gloves on and off.
bleach disinfectant
Time to disinfect your Still Air Box. Add 2.5 Tbsp bleach to 1 quart (32oz) of water.  While its impossible to sterilize your SAB you can greatly reduce the chance of contamination with a simple bleach and water solution.
spray-bottle
Spray down the entire interior and lid of your SAB with your bleach disinfectant solution and allow it to stand for 5 minutes. Wipe away excess moisture with a clean paper towel.